1,Loosen the left side, rear bicycle wheel axle nut. If the bike is outfitted with a quick-release skewer, simply open the arm of the skewer on the ride side of the axle and unthread the left side nut. If the bike does not have a quick release, use an adjustable wrench to unscrew the left side nut from the axle.
2,Slide the plastic tab washer included with the bike trailer over the left side of the axle. It should fit flush against the frame of the bike.
3,Fit the included coupler plate on the left side of the axle so that the tab at the back of the plate fits into the holes on the plastic tab washer. Once installed, the large hole in the coupler plate will be located below the axle.
4,Replace the nut on the end of the axle. For quick-release skewers, tighten the nut with your fingers and then close the lever on the right side of the skewer. For wheels without quick-release skewers, thread the nut on by hand and then tighten fully with the adjustable wrench.
5,Slide the end of the baby bike trailer tow bar into the large hole on the coupler plate. Secure the bar in place by installing the fastening pin, also included, through the eyelet in the coupler plate.
6,Loop the safety strap attached to the tow bar around the tube of the frame extending vertically from the axle, which is called the seat stay. Clip the end of the strap in place on the D-ring on the two bar.
没有评论:
发表评论