Make a Wooden Hammock Stand

Wouldn’t it be nice to have a hammock right in your backyard? This could serve as a sanctuary or a place where you could hang out during the late afternoons. Of course, your hammock will not be complete without a stable stand. Most people busy themselves with getting the right fabric or material to hang on their wooden hammock stands. While this also important, getting a wooden hammock stand should be the first thing you need to worry about when building your own hammock.

1,Cut one end of your 6-foot long wood pieces at a 30-degree angle using your miter saw.

2,Measure 1 foot from each end of your 8-foot wood pieces using your measuring tape. Use your pencil to mark each measurement that you make.

3,Place your 8-foot wood pieces on a flat surface. Find the angled end of your 6-foot wood pieces near the two 1-foot marks. Angle the piece outwards as you place your other 8-foot piece on top. Line up the board according to the measurement marks that you made. This would put the 6-foot pieces in between the 8-foot ones.

4,Use your electric drill to drill 4 holes in all three pieces for every two connecting areas. Get your 1/2 by 2-inch bolts, nuts and washers and secure the wood pieces with them. See to it that they are tightly screwed by turning the knobs clockwise until they come to a complete stop.

5,Measure the pieces to find their 4-foot section. Put the 8-foot wood pieces’ends near the center. The 4-foot wood pieces will serve as the stand’s base when the hammock stands are held upright.

6,Drill one hole using the electric driller through the 4-foot pieces. Repeat the same step for each side of your 8-foot wood pieces. You should end up with 2 holes on each end.