DIY Bicycle Trailer Hitch

1,Measure the distance from the mattress of the trailer amid its horizontal position apt the ground and quantity the distance from the media of the bicycle's seat tube apt the floor while the bike is in one upright position. Subtract the 1st measurement from the second, and tear a width of plywood to the inconsistency using the lumber saw. This chip ambition ascend vertically off the bed of the trailer, and must be securely attached apt the bed with bolts alternatively screws, with the 3/4" face oriented toward the bike.

2,Measure the horizontal distance from the chair tube backwards to a spot a few inches beyond the rear cycle and cut 2 similarly pieces of plywood to this length,joining three inches. These pieces longing straddle the perpendicular piece and will run horizontally over the top of the wheel apt a standing ovation the preside tube.

3,bike trailer,Drill a 1/4"aperture amongst the ends of the 2 horizontal plywood pieces,centred 3/4"surrounded from the annihilate These ends ambition fall in love with the chair tube when the trailer is hitched up.

4,Trim away the corners from the ends of the horizontal pieces,narrowing the breadth down to 2"aboard the annihilate where the pieces aspiration encounter the preside tube. The trapezoidal fashion namely results should allow the horizontal pieces to pivot left apt right without kicking the seat alternatively additional portions of the bicycle border.

5,Drill 3 holes amongst the ends of the three lumber pieces,bike trailer stroller, and anchor them tightly together with nuts and bolts among the following manner: the horizontal pieces ought be parallel apt every other,baby bike trailer stroller,on opposite sides of the perpendicular chip forming a right angle with the vertical so is the trapezoidal ends of the horizontal pieces longing extend over the height of the bike's rear wheel apt encounter the chair tube. Trim the timber pieces for necessary to make sure all the pieces longing explicit the rear wheel when the trailer namely hitched up. Make sure the holes on the trapezoidal ends of the horizontal pieces are lined up so the fourth bolt can pass easily amongst them.

6,Cut a one 1/2" x 9 rectangular chip from the tire rubber using the hacksaw. Drill a 1/4"hole approach one annihilate of the chip,then several more holes approximate the additional annihilate spaced out from each additional favor the holes among an adaptive strap.

7,Hitch up the trailer according passing the rubber chip approximately the chair tube,after bringing the ends together between the two wooden horizontal pieces. Pass the 1/4"lock through one of the wooden pieces,next amongst two holes among the rubber chip and out the other side of the second horizontal piece before adding the washer and closing the hitch forward screwing aboard the wing nut. Experiment with the different holes on the rubber chip to cinch it more tightly alternatively loosely approximately the seat tube,impartial as with a strap The two wood pieces may bend within towards every additional to constrict the connection as well.