Wire Trailer Lights

one,red massage table,Locate your vehicle's taillight wiring saddle normally found surrounded the trunk alternatively around the rear bumper.

2,Locate a spot for your fasten up,13ft trampoline net, making sure the wiring harness namely long ample apt reach your trailer' s connector receptacle If it is never long ample you will must purchase more cord alternatively an additional connector by your regional automatic parts store.

3,Use the clip kill of your "test light" and clean off a small zone of metal on chassis apt use as your floor Then turn the headlight alternate so that the parking light is aboard Using the test light,8ft trampoline pad,probe the wires until it lights up. If it comes on and stays aboard you are ready to connect the brown cable to that cable with a quick connector. Turn your headlights off onward proceeding.

4,Turn the ignition aboard and admit the right corner arrow Using the test connector, repeat the process of probing the test light until the trailer's corner arrow comes aboard and stays on; this is the wire that want be the right corner arrow and right brake light wire; connect the yellow cable to this cable Turn the ignition off.

5,Turn the ignition alternate on afresh reserve it among the flee position and refresh the left corner arrow Once afresh needle the wires with the test light until the light flashes. This wire ambition be the left edge pointer and left stop light wire; connect the green cord to this cable Turn off the ignition.

6,Attach the pearly cord apt your floor cable If you do never already have a floor cord to a standing ovation the pearly cable clean off an district of metal aboard the chassis for your floor and connect the pearly wire using a canvas metal screw.