Make Cot Sheets

an,Measure your mattress from the pedestal fringe of one side, up and along the breadth and down apt the found edge of the additional side. Add three inches to this measurement. Then amount the length in the same manner and add three inches apt it.

2,Purchase bedding fabric broad enough so you won't have any seams amid the sheet Cut the napkin apt your measurements.

3,Lay the cloth with the wrong side up aboard your mattress and centre it so that all sides are hanging down from the mattress equally. Fit the corners forward bringing the sides together apt create a dart Pin the darts attach apt form the corners of the sheet.

4,Lay every corner aboard a table or hard surface and, using tracing periodical and a tracing cycle,mark the lines that you have pinned. Remove the pins for you go along. Then district the pins perpendicular apt the traced lines that are holding them accompany for sewing. Sew each corner throw aboard the wrong side of the material and explicit the pins.

5,Fold the crude edge over 1/4 inch with the wrong sides of the material facing each other and iron it down. Then fold it over afresh 1/2 inch for the hem. Sew entire the access approximately leaving a small opening by the annihilate to insert your elastic.

6,folding camping cot,Measure the distance nearly the mattress and discount four inches. Cut your elastic to this measurement. Attach a safety pin apt one annihilate of the elastic apt your opening. Place a safety pin on the other annihilate of the elastic and feed it through the hem. When you obtain behind apt the opening,tug out the elastic and hand sew it to the other end.

7,lightweight camping cot,Place the canvas on your mattress apt make sure it pulls tightly enough If never pluck the elastic amongst and seam it splice an inch shorter for a tighter fit Cut off the accompanying elastic and sew the opening closed with a probe and thread.

Make a Flat Cot Sheet

8,Use the same measurements as for your fitted canvas Cut the fabric.

9,Turn always the raw edges over 1/4 inch with wrong sides attach and iron the fold down. Turn afresh 1/4 inch and seam always the access approximately.

10,camping cot,Turn the altitude width over 2 inches with the wrong sides splice and iron flat. Sew down from the fold and corner Go all the access across and turn,completion back up to the fold.